BATTERY SWITCH / BATTERY DISCONNECT SWITCH / MANUAL POWER ISOLATION

ASW-A71001 ON-OFF switch with 3/8-inch studs

ASW-A71001 is rated at 275 A continuous, 455 A intermittent for 5 minutes and 1,250 A cranking for 10 seconds, for 12-48 V DC systems. DAIERTEK ASW-A71001 is a rotary ON-OFF battery disconnect switch with two 3/8-inch terminal studs. The studs accept matching ring terminals for the incoming battery cable and outgoing circuit cable. The rotary knob provides manual connection and isolation of the battery feed. ASW-A71001 suits aftermarket product ranges and vehicle equipment assemblies using imperial cable connection hardware.

275 A

Continuous Current

12-48 V DC

Operating Voltage

3/8 in

Terminal Studs

ON-OFF

Function

Product documentation

Product Details

01 Configuration built around the switching requirement
The listed configuration supports ON-OFF operation. Buyers can select the appropriate model by circuit function, terminal arrangement, mounting method and electrical rating.
02 Defined terminal and mounting architecture
The product uses 2-terminal with 3/8 in connection sizes.
03 Structured for aftermarket and OEM supply
This product supports distributor ranges, replacement programs, equipment integration and qualified private-label projects. Model marking, labels, packaging and selected mechanical details can be reviewed against project requirements.

Specifications

Model	ASW-A71001
Product Type	ON-OFF switch with 3/8-inch studs
Switching Function	ON-OFF
Terminal Configuration	2-terminal
Stud or Connection Size	3/8 in
Continuous Current	275 A
Intermittent Current	455 A for 5 minutes
Cranking Current	1,250 A for 10 seconds
Operating Voltage	12-48 V DC

Typical battery-switch applications

Automotive Auxiliary Battery Circuits

Manual isolation for accessory or auxiliary battery feeds for service and storage.

RV, Camper and Utility Vehicle Systems

A disconnect point for low-voltage DC systems, installed with suitable cable sizing and circuit protection.

Equipment Service Disconnects

Battery isolation during maintenance, storage or transport when installed in an accessible, protected location.

Aftermarket and Private-Label Programs

A repeatable product platform for distributors and qualified OEM projects.

Install with cable sizes, ring terminals and circuit protection appropriate to the connected load. Short-duration current ratings describe carrying capacity; they do not establish short-circuit protection or permission to disconnect a running engine.

Related battery-switch products

Product	Product type	Selection relevance
ASW-A701	275A ON-OFF battery switch	Two M10 copper studs; rotary single-circuit control.
ASW-A701S	275A battery selector	Three M8 brass studs; 1 / 2 / BOTH / OFF selection.
ASW-A705 Series	Compact panel-mount ON-OFF switches	50 A, 100 A, 200 A and 300 A choices.
ASW-A720	600A ON-OFF battery switch	Two M12 studs; larger high-current connection interface.

Alternative DAIERTEK battery-switch configurations are shown for selection reference.

Technical information for ASW-A71001

Contact DAIERTEK for available dimensional drawings, terminal information, operating-life data and packaging options for ASW-A71001. Qualified projects may request model marking, logo, control or label treatment, mounting accessories and packaging, subject to technical review and order requirements.

Request Technical Documents